1. The load of the mowing boat is too large: Check the load size. Under correct load conditions, control within a reasonable range.
2, time load foreign invasion, inflow: improve the sealing device, rust stop. Improve the surface finish of paired rolling parts. Showing the dark side, there is slight wear, the surface has deep dark 5-10 m microcracks and the micro shedding (slight peeling) fracture installation occurs in a wide range from the surface inward. Improve the sealing device.
3, briquette equipment poor lubrication, inappropriate lubricating oil: the use of appropriate viscosity lubricating oil lubrication improvement. Poor surface finish of pairs of rolling parts. Foreign matter has entered the lubricant. Choose the right lubricant for the mowing boat.
4, mowing boat bearing clearance is improper. Bearing housing accuracy is poor, rigid bearing box is unfair: check the shaft and bearing accuracy room. Check the gap.
5. Shaft deflection, a little rusting of large, erosion, wear, indentation of check-axis, and precision bearing housing. The bearing load of the ball press rotates the inner ring, the outer ring raceway surface or the rolling fatigue brings up decent scaling off. Surface mowing boat so-called damage caused by damage produced by sliding surface partial surface damage minor burns summary. Surface roughness due to poor lubrication. It is improper to strip lubricating oil. Improve lubricating oil and lubrication methods.